Difference between revisions of "GDC/Test Suite"
(Created page with "{{ParentArticle|GDC}} == Running the testsuite == Execute this command in the directory where you've run '''configure''' (see GDC/Installation) to run the D test sui...") |
(→Running the testsuite: Add info about timeouts) |
||
| Line 27: | Line 27: | ||
make check-d RUNTESTFLAGS="--target_board=unix/-fno-section-anchors/O3" | make check-d RUNTESTFLAGS="--target_board=unix/-fno-section-anchors/O3" | ||
</syntaxhighlight> | </syntaxhighlight> | ||
| + | |||
| + | === Adjusting the timeouts === | ||
| + | The test suite always enforces a certain timeout when compiling a testcase with gdc. If you see ''UNRESOLVED:'' lines in your build log with a ''program timed out'' warning your machine is too slow and you have to increase the default timeouts. | ||
| + | |||
| + | To change the timeout, edit ''/usr/share/dejagnu/config/unix.exp'' and add this line at the end: | ||
| + | <syntaxhighlight lang="bash"> | ||
| + | set_board_info gcc,timeout 1200 | ||
| + | </syntaxhighlight> | ||
| + | where 1200 is the new timeout in seconds. | ||
== More information == | == More information == | ||
[http://gcc.gnu.org/install/test.html GCC test suite documentation] | [http://gcc.gnu.org/install/test.html GCC test suite documentation] | ||
Revision as of 07:30, 8 August 2013
Contents
[hide]Running the testsuite
Execute this command in the directory where you've run configure (see GDC/Installation) to run the D test suite:
make check-d
Note: You must have built the gdc compiler using make before running the tests.
The summary and log will be saved in gcc/testsuite/gdc/ as gdc.sum and gdc.log.
XML output
To obtain xml output for the summary, use this command:
make check-d RUNTESTFLAGS="--xml"
Passing options to gdc
To pass an option to gdc which is used in every test run, use this:
make check-d RUNTESTFLAGS="--target_board=unix/-fno-section-anchors"
The unix part must always be included. Flags are then separated by /. For example, to pass -O3 and -fno-section-anchors, use this:
make check-d RUNTESTFLAGS="--target_board=unix/-fno-section-anchors/O3"
Adjusting the timeouts
The test suite always enforces a certain timeout when compiling a testcase with gdc. If you see UNRESOLVED: lines in your build log with a program timed out warning your machine is too slow and you have to increase the default timeouts.
To change the timeout, edit /usr/share/dejagnu/config/unix.exp and add this line at the end:
set_board_info gcc,timeout 1200
where 1200 is the new timeout in seconds.
